Standard Service Company - GENIE InfraRed Safety Kit(35048R)

General Information

This item in stock

Replaces most GENIE infra-red photo cell systems.
Beams have screw terminal connections and come with mounting brackets and hardware. Compatible with Genie brand garage door openers only. The garage door opener will not close the door automatically unless the Safe-T-Beam system is installed. Mounting brackets can be attached to masonry or floor using concrete anchors ( not provided ).
If garage has only one garage door determine which side of garage receives most direct sunlight, red LED should always be on sunny side whenever possible. For multiple garage doors place source red LED and sensor green LED modules on adjacent garage doors facing in opposite directions.
To help prevent interference from the sun, STB modules may be placed further away from the garage door opening where they will spend more time in shadows.
If existing wiring is not defective, do not replace. If wiring requires replacement, use only insulated staples when attaching wire to walls and woodwork. Staples which are to tight can pinch wires. Cut or pinched wires can cause the STB system to stop working.
Make sure that no part of the garage door or its hardware is in the path between lenses of source red LED and sensor green LED. Make sure that tops of lenses are between 5"-6" above the floor. The brackets are flexible, and can be adjusted slightly if needed. If the STB's are not in proper alignmemt, the source red LED will blink continuously. To correct the problem you can adjust either bracket slightly to bring the system into alignment. When the STB's are in alignment the source red LED will stop blinking and stay on. If a problem exists with the STB system that is preventing the garage door from closing, the garage door can be closed by holding the wall control button in until the garage door is fully closed. ( the remote control will not work ).

Product Catalog